How is the high-pressure water actuating structure processed? How to adjust the balance pressure?

In order to achieve good results, we need to consider the factors in the manufacturing field. High pressure water execution structure has a very important effect in the industry field, and the application of high pressure water execution structure in the hydraulic transmission system has a very important effect.

When the high-pressure water actuating structure is manufactured, it is not necessary to strictly supervise the selection of raw materials, and the industrial production of crimping connector is also critical. Many people do not know how to carry out the actual operation in the case of making rigid wire, coiling high pressure water to execute the overall process of the structure.

Before the application of the high-pressure water actuating structure, it is necessary to carry out the corresponding detection work. Check whether the plastic hose and the connector housing are installed in time, whether the front of the sleeve specification enters the annular groove cut on the face of the cylinder outside the core, and whether the tightness matches these. Too tight will change the shape of the inner hole of the connector core. If the high-pressure water actuating structure is too loose, the connector of the high-pressure water actuating structure will fall off very easily, Therefore, this must not be noticed.

1、 The high-pressure water actuating structure must be strictly implemented to better play its role. When using the high-pressure silicone hose, the bending radius of the sheet metal should not be lower than the given bending radius, so as to avoid harming the high-pressure water actuating structure to the silicone hose structure or causing initial damage due to too much browsing.

2、 According to the relevant conditions of the application of high-pressure water actuating structures, we must reasonably select high-pressure silicon tubes to prevent misuse or maintenance.

3、 During the application of high-pressure water actuating structure, the working pressure must be balanced and adjusted slowly to prevent the pipe from being destroyed due to sudden working pressure.

4、 When the high-pressure water execution structure is changed in four working locations, please try not to clean the high-pressure silica gel hose when air handling, so as to prevent the plastic etching the structure layer after scratching.

5、 The high-pressure water actuating structure conveys corrosive liquid, and then the internal structure of the high-pressure silica gel hose must be cleaned and processed. After that, the high-pressure water actuating structure can reasonably avoid the long-term erosion of the remaining tubes, or select the corresponding product series.